diff --git a/headless-scripts/Readme.md b/headless-scripts/Readme.md
index 511dafd..94edace 100644
--- a/headless-scripts/Readme.md
+++ b/headless-scripts/Readme.md
@@ -11,7 +11,7 @@
 ## Configure the SD card before first boot of the Pi
 
 
-1. Flash the image from [here (10-24 dated image)](https://www.dropbox.com/s/6f8kxenvtz8pkj9/image_2018-10-24-teslausb_headless-lite.zip?dl=0) using Etcher or similar. 
+1. Flash the image from [here (10-24 dated image)](https://www.dropbox.com/s/6f8kxenvtz8pkj9/image_2018-10-24-teslausb_headless-lite.zip?dl=0) using Etcher or similar.  (Be sure to click the `...` on Dropbox and download the `.zip` file.)
 1. Mount the card again, and in the `boot` directory create a `teslausb_setup_variables.conf` file to export the same environment varibles normally needed for setup (including archive, Wifi, and push notifications (if desired).) A sample conf file is in this repo.  I.e. file should contain at a minimum (replace with your own values):
     ```
     export archiveserver=Nautilus
@@ -78,4 +78,4 @@ Built image on a Raspi running Stretch, for maximum Pi-ception.
 1. (Yes at this point you could suggest that just putting the end state files in place instead of patching would be good, but why not be idiomatic? :)  )
 1. Add a script to flash LEDs
 1. Run `sudo ./build.sh` from the `pi-gen` directory.
-1. If you get a failure, it's almost certainly after stage2, so you can add SKIP files in stage2-stage5 present) and rerun `sudo CLEAN=1 ./build.sh`
\ No newline at end of file
+1. If you get a failure, it's almost certainly after stage2, so you can add SKIP files in stage2-stage5 present) and rerun `sudo CLEAN=1 ./build.sh`